Home > Transmission Tuning 70cc >

Variator-Kit -MALOSSI MHR Team Racing - Piaggio 50cc


Our Price: $130.21

Availability:: Usually Ships in 24 Hours
Product Code: M5112645

Variator-Kit -MALOSSI MHR Team Racing - Piaggio 50cc
The new 2008 MHR TEAM Multivar is different from the previous one for the bigger hub diameter which, passing from 20 to 22 mm, improves its smoothness, reducing frictions and allowing a linearity of the change gear never reached before! The kit contains a 99.5 mm diameter mobile half pulley made of a special cast aluminium alloy. The contact surface between pulley and belt is super-finished with a diamond tool to grant a constant coefficient of friction, calculated to prevent both belt slip and premature wear. To satisfy the innumerable adjustings required by racing scooters, depending on the track type and on the tuning of the engines, the kit is supplied with 2 sets of 6 rollers and a counter-spring in pre-hardened silicon-chrome steel alloy with counterclockwise winding (racing). In addition, other springs of the same class with different loads are available as options. The variator is supplied with two different roller sets: one of 3.9 gr. and one of 4.7 gr. in order to change the number of revolutions of the gear curve of your vehicle perfectly adjusting its speed and acceleration.

Average Customer Review: 4 of 5 Total Reviews: 1 Write a review.

  2 of 3 people found the following review helpful:
V2008 variator for Piaggio May 26, 2010
Reviewer: rd400guy from Wyomissing, PA  
The stock rollers it ships with are WAY too light for a Ditech motor.  If you have a carb, and can rev up to 12k, then maybe.  My Piaggio Ditech SR Factory needed heavier than stock roller weights in the 6.15g range, and the lighter purple spring is must as well.  But it added a few MPH to my top end.  Acceleration is better than stock variator - according to the butt dyno.

Was this review helpful to you?